NB Miata phone mount

I needed a good phone mount for my 04 Miata. I found the cupholder that I remixed here and realized that I could use the way it connects to the car and make a phone holder arm for it that would keep it somewhat out of the way and close enough to my Android Auto deck to plug my phone into the USB port easily. That is what this model is; a phone mount that uses the screw on the passenger side of the center console that keeps the phone close to the deck.The arm mounts a little loosely so I covered the mount piece of the arm with some thin, self-adhesive felt which not only made it a secure fit but keeps it from rattling around as you are driving. There is also an optional, inner liner file I printed in TPU and superglued in to make the phone have a secure fit, avoid scratches, and dampen any noise from the phone bouncing around.My only complaint is that I sometimes bump the phone when I shift into 5th gear. I drove around with this a good bit the day I made it and, by the end of the day, I was already adjusting my hand position without thinking about it so that I didn't bump my phone when shifting into fifthI printed this way:- the mount - oriented vertically, .2mm layers “strength” mode, PETG (no supports)- the arm - oriented vertically, .2mm layers “strength” mode, PETG (regular supports) - I tried printing laying down to minimize supports and it was a much rougher print this way- the liner - .2mm layers, 100%infill, TPU95