Tesla Model 3 Center Console Tray (Modified from jonco223)

SummaryThis is a center console tray (with coin tray) remix from jonco223's design. The original design is great but I just have some pet peeves that I needed to modify...The following are the modifications:Fix - The wall thickness below the coin tray is too thin for 0.4mm nozzle to print, I was getting a pin-hole in my original print.Fix - The step-down from the top ledge is rubbing against the center console cover. I recessed it back 10mm. This problem will show up if you plan on flocking the tray - the rubbing will rub off the flocking fibers and the paint.Mod - Added a partial opening in the front of the tray to allow cable or light to come thru from the bottom of the center console.Mod - Rounded out most of the straight edges in the tray as (and I'm still learning) sharp corners don't stick to flocking fibers too well.Print SettingsPrinter: JGAurora A5 Rafts: No Supports: No Resolution: 0.3 Infill: 30% Notes: Very easy print, nothing to worry about.