Miata Steering Rack Limiter

I recently got the Little Big Brake Kit from Flyin' Miata but encountered a problem after installing it.The initial straight part of the braided brake line connected to the calipers could hit the ABS cable holder when at almost full steering lock (I had about 5 mm of travel left in the rack).To prevent any damage, I printed two spacers to limit the steering rack travel.These spacers sit flush with both the rack and the tie rod collar.I used them on an NB2 with power steering, so keep that in mind if you are printing them for your NA or other models, as I am not sure if they are compatible. Note that the right side of the steering rack requires a bigger spacer because it has more travel.I printed them using Nylon P12 mixed with carbon fiber.