MAZDA MX5/MIATA NA & NB - HARDTOP REAR SPOILER

This is a hardtop spoiler for a Mazda MX5 / Miata NA & NB & NBFL (Mk1, Mk2 & Mk2.5) from '89 - '05 that I designed. This was designed from a high quality 3D scan of the car so the part is a perfect fit for the glass, and rubber seal. As you can see from the pictures, the spoiler is touching the glass for about 15mm, allowing you to use this part to use the double sided tape and ensure a quality bondo. The spoiler is printed in different parts that are aligned together using a Dowel and then welded together using a 3D pen or molten plastic in a specific canal left in between each parts, this way you will ensure perfect bonding while maintaining structural integrity of the spoiler. When you buy the design you'll have access to the V1 and the latest design with the canal's included. The process I used to assemble this spoiler was: 1 - Print all the pieces and dowels, assemble. 2 - Using a 3D pen, weld all the pieces together 3 - Sand down until you have a relatively smooth surface with no super high points 4 - Apply a thin layer of bondo or if you have already quite a smooth surface apply Spray Body Filler/Primmer 5 - Sand until you achieve your desired surface finish 6 - Paint with your desired colour 7 - Clean the surface of the spoiler and the mating surface with Isopropyl alcool 99% 8 - Use double sided tape (ideally 3M VHB 5952)