NA miata sway bar link bushing

This is to be printed from TPU 95a The file provided has half a bushing. It is a two part design. you need to print 4 for a corner. two to make one bushing. Remove your old bushing from the link and remove the sleeve in the old bushing to use in the new one. You MUST use a washer on the top bushing to stop the bushing popping out. I'd recommend one that is ~33mm outer diameter with an inner diameter of ~ 17mm to fit the bolt through.Disclaimer:This 3D print file is provided for personal, non‑commercial use only. It is offered “as is,” without any guarantees or warranties of any kind, whether express or implied. By using this file, you acknowledge that you are solely responsible for the printing, assembly, modification, and use of any resulting parts. I do not assume any liability for damage, injury, malfunction, or loss that may occur from the use or misuse of this file or any printed components. I do not allow this file to be sold by any means digitally or printed.