Tesla Sunglasses Holder - Stronger, Easy Support

Boost MeThe original Tesla Sunglasses Holder works great, but I had to print so many to get one of them usable. The little tab kept breaking - once when I was pulling from the bed. Another time when I was installing it. And the tree supports are such a pain with PETG - they never clear out cleanly.So I re-designed this to(1) Print on it's side - so the layer lines go against the weak spot in the tab. Now it's impossible to break off.(2) Have pre-designed support that breaks off super easy.(3) Be a bit slimmer.Note that your Slicer may complain about overhangs. Don't worry about it - there's intentionally a .3mm gap between the parts, so removing that bottom little support (that you can see in the picture with the print bed) is zero effort.Installation Tip:Make sure the little “nub” goes beyond under the headliner, so the thing doesn't fall on you while driving.On one spot of my car, it went on super easy. In another spot, I used a little plastic knife as a “pry” tool.