Honda CRX Gauge Panel

Fits 1986 Honda CRX SI, I am not aware of the compatibility with the other CRX's or Civics, but I'm sure it does not fit any 2nd generation CRX. The holes are ~52mm and have been slightly adjusted for my case. If the holes are too small then you can use sandpaper and pretty easily fit yours. My AEM wideband gauge has a mounting process that allows me to tighten it if loose, while my boost gauge is press fit. This is designed to print on its front face, giving it a textured look. The holes for screws have one layer of bridged material so that it can print without supports, you can easily punch through this with the screwdriver or anything that would fit in it. I do not recommend PLA, it will warp there is no getting around it. After my failure with PLA, I printed it in PETG and so far so good. If possible, I would say print in ABS or ASA. I originally found this panel on YouMagine, I've made a couple changes, mainly the removal of a cubby area while adding another hole to fit a gauge. As I am writing this the upload was removed. I do not remember what the licensing was for that model so if you are the original owner and wish this to be taken down just let me know.