Tesla Model S/X Refresh Air vent clip holder
Tesla Model S / Model X Refresh Air Vent HolderVent adapters for Model 3 and Model Y are common, but options for the Tesla Model S / Model X Refresh vent design are very limited, so I designed this mount specifically for them.This model was designed completely from scratch, with dimensions measured directly from the vehicle.No geometry or model files (STL / 3MF) from other models were used.However, the general concept was inspired by existing Tesla vent mount accessories.If you are looking for the Model 3 / Model Y version, please refer to the following model:https://makerworld.com/models/1406525CompatibilityThis holder is designed for Tesla vehicles with the horizontal hidden air vent used in the Refresh interiors.Compatible with:Model S Refresh (2021+)Model X Refresh (2021+)Included ModelsThis set includes the following holders:L1 – L4 Holder – Driver side holdersR1 – R5 Holder – Passenger side holders Adapters included:17mm Ball Mount Adapter – Compatible with many phone mounts and accessories15×2 mm Magnetic Adapter – Designed for magnetic mounting setupsSize VariationsDue to small manufacturing differences between Tesla model years, the height of the air vent opening can vary slightly depending on the vehicle year and configuration.Because of this variation, it was not possible to create a single universal holder size.In addition, the passenger side air vent opening is a long curved structure where the height gradually changes from one end to the other.For this reason, multiple size options are provided.Driver side holders:L1L2L3L4Passenger side holders:R1R2R3R4R5These sizes allow users to select the best fitting holder depending on their vehicle.Tested Size RecommendationThe following size recommendations are based on real-world testing on actual vehicles.Because Tesla may introduce small changes to the air vent geometry depending on the production year or configuration, the best fitting size can vary slightly between vehicles.The sizes below reflect the results from vehicles that were physically tested.Tested Model S2023 : L1 / R12026 : L2 / R1 or R2Tested Model X2023 : L2 / R32024, 2025, 2026 : L4 / R3 or R4 Please use these results as a reference when choosing your holder size.If you test this model on a different vehicle year, your feedback would be greatly appreciated.As more test data becomes available, this model description will be updated with additional recommendations.InstallationGently lift the dashboard edge above the air vent using your fingers.Slide the holder into the gap above the air vent.Push until the holder is firmly seated.Important (Driver Side Installation)This instruction applies only to the driver side holders.The air vent has two horizontal openings (upper and lower).When installing the holder, make sure it is positioned exactly at the center of the upper air vent opening (dashboard side).Installing the holder off-center or in the lower opening may reduce stability.To help protect the vehicle interior, wrapping the holder with Tesa tape is also a good option.Printing RecommendationsSince this model is used inside a vehicle, the interior temperature can become very high in sunlight.For this reason, please use PETG or higher heat-resistant filament.Recommended materials:PETGABSASAPLA is not recommended, as it may deform under high temperatures inside a vehicle.Feedback RequestIf you leave a review after using this model, it would be very helpful for other users if you include:Your vehicle model (S or X)Vehicle year / configurationWhich holder size you used (L1–L4 or R1–R5)This information will help future users choose the correct size more easily.Check out my other Tesla accessories at the link below.https://makerworld.com/en/collections/23596043-my-tesla-models
