Threaded Oil Funnel Honda with Breather
The Funnel is tested on Honda Civic 2015 and Honda Jazz 2015. Supposed to fit models from Acura, Nissan and some Fords. Now with a Cap. Per request, I have made a 75 mm (~3 inch) extension. The breather pipe fits perfectly, at least on the Bambu printer and with the filament I used. There is a stopper to ensure that the profiles overlap correctly. There is also 40 Degrees Angle Adapter, but you must first scheck the aligment with the Thread and Degrees Checker. A combined Thread and Degrees Checker profile with the thread only is included, so you can check if the funnel fits your car without printing the entire model, or check if you mist rotate the thread for the 40 Degree adapter and with how much. EDIT: Now there is a V3 version with one extra wall, for a total of four. I tried the funnel for the first time with Bambu PETG-HF Black (just dried), and the walls were too pliable, causing some crackling noise. With four walls, it is more stable. With PLA, the three-wall version is still strong enough. Confirmed fit on:Honda Jazz GK3 2015Honda Jazz 1.5 L15A1 EngineHonda Civic 1988Honda Civic 2004Honda Civic FK3 2015Honda Civic FK8 Type RHonda Civic Touring 2016 1.5 LHonda Civic 2021 1.5LHonda Civic Sport 2025Honda Civic Si 11th Gen 1.5T FE1Honda CR-V 2002-2006 with the K24A1 engineHonda CR-V 1997Honda CR-V 2009Honda CR-V 2017Honda CR-V 2018Honda CR-V 2021Honda CR-ZHonda Accord 2015 with the K24 engineHonda Accord 2017 2.4LHonda Integra with RDX engineHonda Integra Type S 2024Honda S2000 AP1 / AP2Honda S660Honda Pilot 2023-2026 with two extentions.Mistubishi MR TritonInfinitiNissan Skyline R34 with RB25DET engineNissan Skyline RB26Nissan Qashqai J10 2.0Kia Sedona 2012Hyundai Veloster 1.6L Scaled up to 108.33% Boost MeIf you enjoyed this model, please consider boosting it to support the creator. Thank you!
