BMW M52/S52 CCV Delete to Universal Catch Can

This kit will help you run a Universal catch can setup on your M52 or S52 engine using plug-in play components and the hardware that comes with the catch can at an amazing value! What comes with this kit: (* Is what is needed to match the setup in the images) 3x different fittings for 5/8" ID hose at different bend degrees (45, 90, 135) 1x Catch Can Bracket* (uses two of the original bracket mounting short hex bolts and one long mounting hex bolt) 1x Catch Can Bracket Spacer* 1x Catch Can Bracke tie Down* 1x Intake Manifold Plug 90 Degree* 1x Twin Hose clamp Bottom* (Uses Longer hex bolt that comes with catch can) 1x Twin Hose clamp Top* 1x Valve Cover Vent Fitting Route to Front Right* 1x Intake Manifold Plug Delete (Used for PCV hole if you want to vent to atmosphere from the Valve cover) (Following is used for mounting a catch can on the front left side of the vehicle, NOT TESTED by GSM) 1x Valve Cover Vent Fitting Route to Front Left Simple 1x Valve Cover Vent Fitting Route to Front Left (NOTE: This kit will not work with vented catch can setups, only models similar to the one in the image that retail from $20-$40, It is intended to be used with 5/8" (15.875mm) ID hose reinforced, which could be the ones used in coolant applications and is recommended to obtain around 7 feet of if you'd like to match this setup, As well as at minimum 2 additional 7/8" or 1" Hose clamps, Lastly using the OEM CCV hose o-ring for the PCV hose that connect to the valve cover and the original gray gasket for the PCV system for the intake manifold), Finally you will also need simple PCV valve to restrict the vacum pressures since if you just connect 5/8 to outlet on the catch can too much vacuum pressure will be present which will cause your vehicle to run rough and can cause damage! If you have any issues with Form Fit or Function of the STL files, please reach out, and I'd be glad to resolve any associated issues.