Tesla S3XY Knob - Carbon Fiber overlay EnhanceAuto

I have bought Carbon Fiber for the middle console… the S3XY knob stood out to much - so i used the vector file from Enhance auto directly and extruded it to 3D, i scaled it up a bit, since the original was a bit too small - printed with 2 layers on a Carbon Fiber pattern plate with PETG (Sunlu HS Matte PETG black)print at 0.16mm gives a good quality and 15 minutes print time.85 degress bed255 degress nozzleno fanthe orientation is scewed by 10 degrees on the build plate to match the pattern angle of the bought stickers. (you can adjust as preferred)slow down the first layer to 20mm/sApply with some glue or doublelayer-tape if preferred.